article thumbnail

ArcelorMittal publishes concept for global low-carbon emissions physical steel standard

Green Car Congress

ArcelorMittal published a concept for a low-carbon emissions steel standard to help incentivize the decarbonization of steelmaking globally and support the creation of market demand for physical steel products which would be classified as lower, and ultimately near-zero, carbon emissions steel.

Standards 431
article thumbnail

Emissions Analytics argues that current Pareto-efficient solution for decarbonization would be hybrids, not BEVs, based on do-no-harm

Green Car Congress

On this basis, and of Pareto efficiency, Emissions Analytics argues, until battery-electric vehicles can reach certain performance characteristics, government and industry support should switch immediately from EVs to full hybrids to create maximum welfare. The test cycle was made up of five repeats of the EQUA cycle, totalling 741 km.

Emissions 395
article thumbnail

SwRI CAT-DEF reduces heavy-duty diesel emissions to meet CARB 2027 NOx requirements

Green Car Congress

The internally funded advancement successfully reduced heavy-duty diesel engine nitrogen oxide (NO x ) emissions to meet the California Air Resources Board (CARB) 2027 standards. Today’s diesel engines use selective catalytic reduction (SCR) to abate NO x emissions. DEF—a 32.5 g/hp-hr standard. —Wheeler et al. Wheeler, S.,

Diesel 284
article thumbnail

Maersk sets net zero CO2 emission target by 2050

Green Car Congress

The maritime industry emitted close to 1000 million tonnes of CO 2 in 2012, representing about 2.2% of global CO2 emissions. This makes the sector pivotal in bringing down global emissions. In comparison, a container vessel carrying thousands of TEU sailing from Panama to Rotterdam makes around 8,800 km. Moller - Maersk.

CO2 286
article thumbnail

CV industry gears up for a challenging tech transition; some bet on only two options for industry and govt investment – ET Auto

Baua Electric

Even as CV industry players, including Ashok Leyland launch CNG and LNG trucks, these fuel need not be pushed as that may amount to “just distracting ourselves”. The Union Government’s directive to the industry is also clear – move away from fossil fuels including diesel. For the CV industry , it can be a case of easier said than done.

article thumbnail

Nucor investing in start-up company Electra developing zero-carbon iron technology

Green Car Congress

This material will be used in the steelmaking process to offset other high-quality metallics that come with higher greenhouse gas emissions. Electra’s process results in zero carbon dioxide emissions. —Leon Topalian, Chair, President and Chief Executive Officer of Nucor Corporation.

Carbon 293
article thumbnail

Norwegian startup Blastr plans €4B green steel plant in Finland

Green Car Congress

Blastr has entered into a Letter of Intent with Nordic energy company Fortum that provides Blastr exclusive rights to utilize the existing industrial site located in Joddböle, Inkoo in Finland, 55 km west of Helsinki. With the green steel produced in Inkoo, we aim to reduce carbon emissions by 4.6 tonnes of CO₂.

Finland 437