This site uses cookies to improve your experience. To help us insure we adhere to various privacy regulations, please select your country/region of residence. If you do not select a country, we will assume you are from the United States. Select your Cookie Settings or view our Privacy Policy and Terms of Use.
Cookie Settings
Cookies and similar technologies are used on this website for proper function of the website, for tracking performance analytics and for marketing purposes. We and some of our third-party providers may use cookie data for various purposes. Please review the cookie settings below and choose your preference.
Used for the proper function of the website
Used for monitoring website traffic and interactions
Cookie Settings
Cookies and similar technologies are used on this website for proper function of the website, for tracking performance analytics and for marketing purposes. We and some of our third-party providers may use cookie data for various purposes. Please review the cookie settings below and choose your preference.
Strictly Necessary: Used for the proper function of the website
Performance/Analytics: Used for monitoring website traffic and interactions
If improperly installed, these pieces run the risk of detaching. However, it doesn’t seem to come down to individual trims and is instead reliant on the defective parts — which would have been installed on SUVs assembled between October of 2018 and May of 2025.
Azerbaijans Pivot From Oil to Solar and Wind Of the six countries that make up the Caucasus region, Azerbaijan boasts the largest potential for generating exportable renewable energy for Europe, a fact that presents some measure of irony. A 2022 road map from the World Bank, the International Finance Corp.,
Subaru has chosen the New York International Auto Show as the place to debut the 2026 redesign of the Outback. The new Outbacks are also supposed to be quieter, with more sound-deadening materials being installed into the roof and headliner.
When the platform for a prototype floating offshore wind turbine arrived at a dock in Searsport, Maine, on April 11, engineers at the University of Maine were ready to add a tower and a turbine and set it afloat in the Gulf of Maine. In response, wind developers are pulling back on U.S. portfolio , citing the political environment.
Solar, wind, hydro, and other renewable sources are rapidly replacing fossil fuels. The sun doesn’t always shine, and the wind doesn’t always blow. In a grid increasingly powered by fluctuating sources like wind and solar, forecasting accuracy becomes crucial. Schedule backup power from batteries or fossil plants.
the leading global provider of auxiliary wind propulsion systems, announced the installation of five tilting Rotor Sails ( earlier post ) on board a new-build Very Large Ore Carrier (VLOC) chartered by Vale, the Brazilian mining company. Norsepower Oy Ltd.,
the leading global provider of auxiliary wind propulsion systems, and SEA-CARGO, leading logistics provider in the North Sea market, announced an agreement to install two of Norsepower’s largest Rotor Sails ( earlier post ) on board the SC Connector , a sidedoor Ro-Ro. Norsepower Oy Ltd.,
Cuba’s Renewable Energy Options Heavy crude oil isn’t Cuba’s only resource; it has a wealth of untapped renewable energy options, including solar, wind, and potentially sugarcane biomass. Pilot projects for wind farms are underway. Some communities are working together to install solar and battery systems.
The signing of the agreement begins the process of building and installing the first LPG-powered Scuderi power generator and energy storage systems. An internal combustion engine can be used not only for mobile applications (cars) but for stationary power generators as well. Scuderi Group, Inc.,
The recent increase in natural gas or dual-fuel capable reciprocating internal combustion engine units has been driven in part by advancements in engine technology that increase operational flexibility and by changes in natural gas markets that have generally provided ample supply and relatively stable fuel prices, EIA said.
To achieve this, hairpin winding technology is used in the stator as well as combined oil-water cooling. The rotor and stator are internally oil-cooled and the active parts are installed in a water cooling jacket. The new electric motor is available in power ratings between 150 and 230 kilowatts continuous output.
The global rare earth market, driven by demand from industries including electric vehicles and offshore wind, is expected to increase five-fold by 2030 and the NdPr oxide price is forecast to increase at a CAGR of 4.8 - 9.9%, underpinning strong economics for the investment. —Ursula von der Leyen EU President, February 2021.
The extent of my electrical background heretofore consisted of installing lighting fixtures and new wall switches - so long as they were replacements for existing items that got wired the same way. The professional perspective and tips we got was like a taste of interning with the master.
billion contract from independent power producer Caithness Energy to supply wind turbines and provide services for an 845-megawatt (MW) wind farm project to be located in Oregon. The wind farm, called Shepherds Flat, has received the majority of the necessary government permits to operate and is ready to be built.
BP Wind Energy, through its wholly-owned subsidiary Rolling Thunder I Power Partners LLC, has signed a purchase agreement to install a high-storage battery at its Titan 1 Wind Farm in South Dakota. Situated on 7,500 acres in Hand County, Titan 1 Wind Farm is wholly owned and operated by BP Wind Energy.
The report examined grid conditions in the Northwest Power Pool, which covers Idaho, Montana, Nevada, Oregon, Utah, Washington and Wyoming; many of them home to abundant wind resources and wind energy projects. traffic —Tuffner and Kintner-Meyer. This research was funded by the Department of Energy.
Thanks to sophisticated internal interfaces, the new, extremely compact design allows system or component adaptations to be made with little effort. A new cooling concept and a new winding technology play the decisive role here. E-Motor Stator with new braided winding. Integrated differential gear.
together with project partners Maersk Tankers, Energy Technologies Institute (ETI) and Shell International Trading and Shipping Company Ltd., The Rotor Sails were installed onboard Maersk Pelican in August 2018. Norsepower Oy Ltd., As part of the test, the aggregated total fuel saved from 1 September 2018 to 1 September 2019 was 8.2%
TECO 2030 ( earlier post ) is aiming to establish Norway’s first large-scale production of fuel cells, optimized to be the heart of hydrogen-powered ships and other heavy-duty installations. IMO, the International Maritime Organization, targets carbon emission cuts of 40% by 2030 and 70% by 2050, compared to 2008 values.
A rotor sail is a tall rotating cylindrical column on the deck of a ship that provides propulsion from the wind. When wind meets the spinning Rotor Sail, the air flow accelerates on one side of the Rotor Sail and decelerates on the opposite side of the Rotor Sail. Rotor sail technology is based on the Magnus effect. Earlier post.).
A study by an international team of researchers warns that the global transition to global low-carbon energy technology could be at risk unless new international agreements and governance mechanisms are put in place to ensure a sustainable supply of rare minerals and metals. Their paper is published in Science. —Sovacool et al.
The study found the environmental impacts of PHEVs in Alberta would depend on factors such as vehicle battery size, charging time and wind production levels. Of the installed capacity of just above 12,000 MW, approximately 49% (5,893 MW) is coal fired, 39% (4,686 MW) is gas-fired, 7% (869 MW) is hydro, and 4% (497 MW) is wind powered.
The paper examines the Phase 1 results of the DNV-led project FellowSHIP (Fuel Cells for Low Emissions Ships, earlier post ), the first large-scale fuel cell installation operating on board a merchant ship. The GL design concept proposes using wind energy to produce LH 2. Source: DNV. Click to enlarge. DNV FellowSHIP.
Prior to designing the P510 transaxle, Toyota had employed random-wound distributed windings, with the sole exception being the resin-encased, solenoidal MG1 winding used in the P410 transaxle (Gen 3 Prius Liftback, Prius v, and Lexus CT200h). The battery pack is installed beneath the rear seat. Click to enlarge. Battery pack.
Unlike wind, tidal or solar power the advanced design for this Ocean Thermal Energy Conversion (OTEC) system can deliver constant output 24 hours a day. Developed by OTEC International (OTI) LLC of Baltimore, Maryland, the approach converts liquid ammonia into gas in a heat exchanger using warm ocean surface water. OTEC power cycle.
SpaceX has begun preparing its Starbase ‘launch tower’ for the installation of a pair of giant arms designed to lift, stack, and even catch Starships and Super Heavy boosters out of mid-air. Ultimately, though, SpaceX is clearly ready to install both arms on the tower carriage. The Mechazilla Carriage.
For comparison, global final electricity consumption was just over 22,300 terawatt-hours in 2018, the most recent year for which statistics are available, according to the International Energy Agency. So far, only a small hybrid floating solar/hydropower system has been installed, and that is in Portugal. This is really optimistic.
Primary cable segments provide the actual power transfer to the vehicle and are installed just under the road surface. Magnetic shielding under the primary winding (magnetic layer) prevents electromagnetic interference. They convert the magnetic field from the primary winding into alternating current.
billion), boosting international investment into strong manufacturing bases including in the Midlands and North East. The 10 main points of the overall plan are: Offshore wind: Producing enough offshore wind to power every home, quadrupling production to 40GW by 2030.
At the IAA Summit in Munich, HIF Global, together with Porsche AG, Volkswagen Group Innovation and MAN Energy Solutions, announced the development and installation of a Direct Air Capture (DAC) unit at the HIF Haru Oni Demonstration facility in southern Chile in 2024. Earlier post.)
After a decade in the solar power installation business, Bradley Bartz is tired of being Mr. Nice Guy. He’s filed suit against Torrance, the proud home of Exxon/Mobil’s refinery, for stopping him from installing solar panels in the Hillside Overlay district. solar installers. For 10 days apparently. There is also.
H2Carrier developed the P2XFloater concept in a close co-operation with leading maritime and process engineering companies in Norway, thus building on decades of experience and competence from the oil & gas sector, the marine industry and the offshore windinstallation industry.
A123 Energy Solutions has commissioned two installations of its Grid Storage Solution (GSS) product line in China in recent months. to help integrate on-site renewable generation including wind and solar as well as traditional combustion generation at the site’s microgrid.
Covering a total area of 15,000 sq meters, the plant generates its own energy with solar panels and other photovoltaic and wind power technologies, purchases additional energy from renewable sources and buys carbon credits to fully offset its CO 2 emissions. The adoption of Industry 4.0
Due to its compact design, the VEDS requires no additional installation space in chassis designed for combustion engines. Customers receive everything from a single source, from the tank nozzle to the fuel cell inlet, including a patented installation system to accommodate the hydrogen tanks.
A global renewable energy employment report released today by the International Renewable Energy Agency ( IRENA ) and the International Labour Organization ( ILO ) reveals which countries are leading the world in wind and solar manufacturing and installation.
The results of a new analysis by the International Council on Clean Transportation (ICCT) show that, when combined with a trend toward higher methane leakage and combustion slip, there is no climate benefit from using liquefied natural gas (LNG) as a marine fuel—regardless of the engine technology. First, it contains very little sulfur.
Moving Wind Power Offshore The offshore wind (OFW) industry is one of the most rapidly advancing sources of power around the world. It makes sense: Wind is stronger and more consistent over the open ocean than it is on land. Some wind farms are capable of powering 500,000 homes or more. and Norway.
Remy International, Inc. Quantum will install the Remy HVH250 electric machine as the traction motor into a parallel hybrid system that delivers an all-electric range of 35 miles and a hybrid operational range of 400 miles. signed an agreement to supply its HVH250 motors to Quantum Fuel Systems Technologies Worldwide Inc.
The Compagnie Nationale du Rhône (CNR), France’s leading producer of 100% renewable electricity, and Renault signed a partnership agreement at the Lyon International Motor Show. At present it has over 3,200 MW of installed capacity in hydropower, wind power and solar power and aims to reach 5,000 MW in France by 2015.
The scope of work also includes the installation of a new boiler for heating tanks and railcars and infrastructure improvements for rail, truck and marine movements. In 2020, Neste began supplying sustainable aviation fuel (SAF) directly to San Francisco International (SFO) airport via a Kinder Morgan pipeline.
New investment in wind, solar, and other clean energy projects in developing nations dropped sharply in 2018, largely due to a slowdown in China. This is due to wind and solar projects generating only when natural resources are available while oil, coal, and gas plants can potentially produce around the clock. billion in 2018.
meters in height that can be fitted to the deck of cargo ships to harness the power of wind. The installation of the wings took place at the COSCO shipyard in China and the Pyxis Ocean is now on the water, conducting her maiden voyage. —John Cooper, CEO, BAR Technologies On an average global route, WindWings can save 1.5
The company will leverage 24M’s innovative battery casting technology and in-house expertise and experience in automation and mass production systems to construct and install the equipment. The casting and unit cell assembly sits at the heart of the battery cell production process.
We organize all of the trending information in your field so you don't have to. Join 5,000+ users and stay up to date on the latest articles your peers are reading.
You know about us, now we want to get to know you!
Let's personalize your content
Let's get even more personalized
We recognize your account from another site in our network, please click 'Send Email' below to continue with verifying your account and setting a password.
Let's personalize your content