2017 Carbon Convert Polymer 
Green Car Congress
MAY 13, 2016
RMX Technologies and the Department of Energy’s Oak Ridge National Laboratory have signed an exclusive licensing agreement for a new technology that significantly reduces the time and energy needed in the production of carbon fiber. Oxidation is the most time-consuming phase of the multistep carbon fiber conversion process.
Green Car Congress
MARCH 27, 2017
Stuart Licht ( earlier post ) have developed a new process that transforms CO 2 into a controlled selection of nanotubes (CNTs) via molten electrolysis; they call the process C2CNT (CO2 into carbon nanotubes). Molten carbonate electrosynthesized boron-doped CNTs exhibit high electrical conductivity. Licht (2017).
Green Car Congress
FEBRUARY 6, 2017
Now, an international team of researchers in Europe is suggesting a possible approach to convert Li 2 S into sulfur without the detectible formation of polysulfides. we present in this work the synthesis of small, uniformly distributed Li 2 S, particles homogeneously coated by a nitrogen-doped carbon layer. —Vizintin.
Green Car Congress
MAY 25, 2017
This proposal aims to solve these problems by converting organic waste into chemicals with widespread use in polymer and transportation industries. Reaction 35 is applying its platform technology to produce olefins from the nation’s enormous reserves of shale gas in a highly efficient, low cost and low carbon footprint manner.
Green Car Congress
OCTOBER 30, 2019
Shipping requires bespoke low-carbon fuel solutions which can make the leap from the laboratory to the global shipping fleet. Lignin is a structural bio-polymer which contributes to the rigidity of plants. The marine sector has very different fuel requirements than automotive or aviation. Nielsen, Anders Jensen, Line R. 7b00968.
Green Car Congress
FEBRUARY 28, 2017
The new technique, however, has the potential to reduce sulfur down to a fraction of that amount, which would further reduce air pollution and extend the lifetime of vehicles’ catalytic converters, which control tailpipe emissions. Carbon-silicon bonds are found in many products, such as polymers, agricultural chemicals, and semiconductors.
Green Car Congress
DECEMBER 1, 2016
Carbon specialist SGL Group is a development partner in the European joint development project INSPIRE (Integration of Novel Stack Components for Performance, Improved DuRability and LowEr Cost), which has been funded with a €7-million (US$7.4-million) Earlier post.). Gerd Wingefeld, Chief Technology Officer at SGL Group.
Expert insights. Personalized for you.
150 
Let's personalize your content