Carbon Fiber Light Low Cost Waste 
Green Car Congress
AUGUST 10, 2011
This project will identify fuel properties that can be used to enable novel combustion strategies with low emissions of nitrogen oxides in an engine, and enhance existing models to capture the effect of additional key fuel properties on combustion. Light-weighting materials. Wisconsin Engine Research Consultants LLC. 10,000,000.
Green Car Congress
JANUARY 18, 2014
competitive waste heat recovery technologies. based systems for waste?heat Carbon Fiber or Lightweight Materials. VTO is seeking projects that address the major challenges to developing and commercializing carbon fiber composites for lightweight structures. Most critical is the cost of the carbon fiber.
Green Car Congress
OCTOBER 31, 2013
While possibly adequate for some stationary applications and vehicle platforms, they may be too expensive and bulky for many non-stationary applications and may not be able to provide a driving range that meets consumer expectations across the full range of light-duty vehicle platforms. Currently, high-pressure (i.e.,
Green Car Congress
DECEMBER 30, 2022
To date, efforts have been invested in developing carbon fibers, carbon electrodes, porous carbon foam/scaffolds, and carbon nanosheets from asphaltenes. Consequently, research on the valorization of asphaltenes has sparked over the past few years. —Saadi et al.
Green Car Congress
DECEMBER 16, 2010
The engines shall have extremely low engine-out nitrogen oxides (NO x ) and particulate matter (PM) as a target; and shall have efficiency similar to state-of-the-art direct injection diesel engines (i.e., approximately 45% peak thermal efficiency for light duty and greater-than 50% peak thermal efficiency for heavy duty).
Green Car Congress
DECEMBER 20, 2013
Developing cost-effective technologies to improve new vehicle fuel efficiency and achieve or exceed corporate average fuel economy (CAFE) standards of 144 gCO 2 /mi (61.6 mpg) for light trucks by 2025 (54.5 mpg light duty average, or 4.3 mpg) for cars and 203 gCO 2 /mi (43.7 Powertrain friction and wear reduction.
Green Car Congress
JANUARY 13, 2015
Made from a carbon fiber reinforced thermoplastic material by SABIC, the current model of the Strati takes approximately 44 hours to print 212 layers. Local Motors will showcase the proprietary three-phased manufacturing process for 3D-printing cars during NAIAS 2015. The first phase in 3D-printed manufacturing is additive.
Expert insights. Personalized for you.
268 
Let's personalize your content