Automobile Building Carbon Fiber Connect 
Green Car Congress
JULY 12, 2013
Describing its product goals and tracking progress toward its 2020 manufacturing priorities in its 2012 Sustainability Report , General Motors reaffirmed its commitment to further reduce the energy used and the environmental impacts of building and operating an automobile. Earlier post.). GM has a goal of 125 MW renewable energy.
Green Car Congress
SEPTEMBER 13, 2011
research vehicle (the “125” marking 125 years of the automobile), a fuel-cell plug-in hybrid with a range of more than 1,000 km (621 miles) that anticipates more than two generations of vehicles to 2025 and beyond. They are made up of nodal points known as Structural Building Units (SBUs). Mercedes-Benz F 125!
Green Car Congress
SEPTEMBER 15, 2009
All add-on parts—doors, covers, sidewalls and roof—are made of a fiber-reinforced plastic. The combination of aluminum and carbon fiber-reinforced composite material delivers rigidity coupled with low weight. The heat pump—used here for the first time in an automobile—also serves to increase efficiency and range.
Green Car Congress
APRIL 19, 2016
The 2015 papers provided technical details on the high performance fuel-cell (FC) stack; specific insights into FC separator, and stack manifold; Mirai’s newly developed boost converter; and the new high-pressure hydrogen storage system with innovative carbon fiber windings. The 2016 paper by Hasegawa et al.
Green Car Congress
FEBRUARY 2, 2013
Carbon Fiber Polymer Composite. Thus, non-carbonate electrolytes that demonstrably address this issue are of particular interest. The developer should plan to build and deliver high energy lab-scale cells, in the 10 to 250 mAh capacity range, that demonstrate the advantages of the new electrolyte.
Green Car Congress
JULY 30, 2013
With its new architecture, use of carbon fiber reinforced plastic, and premium mobility service offerings, the “ i3 marks the beginning of a new mobility age ,” said Dr. Reithofer. The production of the i3 marks the first time an automobile manufacturing plant in Germany has installed wind turbines on site to directly power production.)
Green Car Congress
NOVEMBER 18, 2014
Two tanks with a three-layer structure made of carbon fiber-reinforced plastic and other materials are used to store hydrogen at 70 MPa (approximately 700 bars or 10,000 psi). Middle layer: carbon fiber reinforced plastic (structural element). Building a convenient refueling infrastructure.
Expert insights. Personalized for you.
275 
Let's personalize your content