Cars That Think
AUGUST 20, 2021
But I was in a hurry and simply mounted on the handlebars a Drok meter , which I had purchased for an earlier bicycle-based battery-charging project. The handlebar-mounted controls connect with an Arduino, which interprets their settings and translates them into a PPM signal, which is applied to the electronic speed controller.
Cars That Think
AUGUST 20, 2021
But I was in a hurry and simply mounted on the handlebars a Drok meter , which I had purchased for an earlier bicycle-based battery-charging project. The handlebar-mounted controls connect with an Arduino, which interprets their settings and translates them into a PPM signal, which is applied to the electronic speed controller.
Cars That Think
SEPTEMBER 27, 2023
Searching the interwebs, I found no shortage of leads about how to build a DIY seismometer. The problem is that the DIY seismometer designs I was seeing were large and ungainly contraptions. I purchased the most bare-bones package for about US $175. The first one I purchased, said to be suitable for Linux, proved a bust.
Electric Vehicless
SEPTEMBER 9, 2020
Front wheel connected conversion kit- very easy to install but less popular. Rear wheel connected conversion kit – In comparison to front wheel little but tough but most popular. Mid drive connected conversion kit – less popular & tough to install. Different connector use for connecting cable. Hub Motors.
Electric Vehicless
SEPTEMBER 6, 2020
Front wheel connected conversion kit- very easy to install but less popular. Rear wheel connected conversion kit – In comparison to front wheel little but tough but most popular. Mid drive connected conversion kit – less popular & tough to install. Different connector use for connecting cable. Hub Motors.
Cars That Think
APRIL 26, 2022
It can be purchased. I connected this. I’ve not used my DIY magnetometer to search for any submarines or alien monoliths, but I did test it using a steel hammer, which affects the readings in an obvious way when placed within about a meter of the sensor board. on Amazon for just US $40.
Cars That Think
JULY 21, 2021
After some consideration, I purchased a 2x4basics custom workbench kit (which provides the bench's heavy-gauge structural resin supports) and lumber to form the main structure, and then cut slabs of chipboard to form a top and a bottom surface. Though this space is generous by most standards, it seems I always needed “just a bit" more.
Expert insights. Personalized for you.
145 
Let's personalize your content