Carbon Fiber Fuel Economy Light Low Cost 
Green Car Congress
AUGUST 30, 2016
LeMond Composites, founded by three-time Tour de France champion Greg LeMond, has licensed a low-cost, high-volume carbon fiber manufacturing process developed at the US Department of Energy’s Oak Ridge National Laboratory (ORNL). Earlier post.)
Green Car Congress
AUGUST 10, 2011
This project will identify fuel properties that can be used to enable novel combustion strategies with low emissions of nitrogen oxides in an engine, and enhance existing models to capture the effect of additional key fuel properties on combustion. Light-weighting materials. Wisconsin Engine Research Consultants LLC.
Green Car Congress
JANUARY 18, 2014
burn systems and controls that allow compliance with proposed EPA Tier 3 emissions regulations with smaller penalty in fuel economy. pressure fuel injection, and higher pressure engine operation, for implementing the clean diesel combustion strategy. Carbon Fiber or Lightweight Materials. derived fuels, drop?in
Green Car Congress
OCTOBER 31, 2013
While possibly adequate for some stationary applications and vehicle platforms, they may be too expensive and bulky for many non-stationary applications and may not be able to provide a driving range that meets consumer expectations across the full range of light-duty vehicle platforms. Currently, high-pressure (i.e.,
Green Car Congress
MARCH 23, 2012
DE-FOA-0000648 ) This funding will support the development of high-strength, lightweight carbon fiber composites and advanced steels and alloys that will help vehicle manufacturers improve the fuel economy of cars and trucks while maintaining and improving safety and performance.
Green Car Congress
DECEMBER 20, 2013
Developing cost-effective technologies to improve new vehicle fuel efficiency and achieve or exceed corporate average fuel economy (CAFE) standards of 144 gCO 2 /mi (61.6 mpg) for light trucks by 2025 (54.5 mpg light duty average, or 4.3 mpg) for cars and 203 gCO 2 /mi (43.7
Green Car Congress
DECEMBER 16, 2010
The engines shall have extremely low engine-out nitrogen oxides (NO x ) and particulate matter (PM) as a target; and shall have efficiency similar to state-of-the-art direct injection diesel engines (i.e., approximately 45% peak thermal efficiency for light duty and greater-than 50% peak thermal efficiency for heavy duty).
Expert insights. Personalized for you.
218 
Let's personalize your content