Green Car Congress

FEBRUARY 24, 2023

MAHLE Powertrain is working with White Motorcycle Concepts (WMC) to develop a fully electric three-wheeled motorcycle suited to the requirements of police, emergency first responders and last-mile delivery fleets. WMC 250EV bike in testing at MIRA, with the V-Duct visible.

Motorcycles 397

Motorcycles Fully Electric Concept Electric Motorcycles 397

Green Car Congress

OCTOBER 31, 2013

The majority of the fuel cell vehicles in today’s demonstration fleets use high-pressure tanks rated at 350 or 700 bar for onboard storage of hydrogen gas. Three overarching performance targets for onboard hydrogen storage systems are: gravimetric capacity; volumetric capacity; and system cost. The Ultimate Full Fleet targets are 2.5

Carbon Fiber 218

Carbon Fiber Hydrogen 2017 Carbon 218

Green Car Congress

JUNE 7, 2013

FCTO anticipates that the FOA may include the following Topic Areas: Topic Area 1: Reducing the Cost of Compressed Hydrogen Storage Systems. Topic 1 will focus on the development of complete, low-cost, compressed hydrogen storage systems. Topic Area 2: Improved Materials for Fiber Composites and Balance of Plant Components.

Hydrogen 199

Hydrogen Carbon Fiber Low Cost Power 199

Green Car Congress

AUGUST 10, 2011

This project will develop a new process that enables low-cost, domestic manufacturing of magnesium. This project will develop a novel low cost route to carbon fiber using a lignin/PAN hybrid precursor and carbon fiber conversion technologies leading to high performance, low-cost carbon fiber.

Carbon Fiber 268

Carbon Fiber Lithium Ion Li-ion Vehicles 268

Green Car Congress

DECEMBER 16, 2010

Such engines may incorporate novel thermodynamic cycles, but should not simply involve regurgitation of existing concepts (e.g., The engines shall have extremely low engine-out nitrogen oxides (NO x ) and particulate matter (PM) as a target; and shall have efficiency similar to state-of-the-art direct injection diesel engines (i.e.,

Li-ion 231

Li-ion Carbon Fiber Vehicles Low Cost 231

Green Car Congress

JANUARY 13, 2015

Made from a carbon fiber reinforced thermoplastic material by SABIC, the current model of the Strati takes approximately 44 hours to print 212 layers. The micro-factory in National Harbor will be where the first fleet of 3D-printed cars will be manufactured and sold. The first phase in 3D-printed manufacturing is additive.

Motor 150

Motor Motors Motoring Carbon Fiber 150

Green Car Congress

DECEMBER 20, 2013

Possible areas of interest for the EV Everywhere Grand Challenge include, but are not limited to: Development of low-cost, high-strength automotive aluminum sheet. Integrated computational materials engineering (ICME) development of carbon fiber composites for lightweight vehicles. Tire efficiency. Multi-speed gearbox.

Vehicles 246

Vehicles Fuel Economy Carbon Fiber Plug-in 246