article thumbnail

Wiring behind dash complete

DIY Electric Car

I''d like to get one that will accomodate DC aircon, power steering and vacuum pump for $200. evworks has this DC aircon unit for $1700. Since I don''t have the DC-DC I haven''t connected the vacuum pump yet so it will be a slow drive.' Lots to choose from but only a few with 12-12.5v Could take a while.

DC 100
article thumbnail

Electric Bike Conversion Kit Selection

Electric Vehicless

Front wheel connected conversion kit- very easy to install but less popular. Rear wheel connected conversion kit – In comparison to front wheel little but tough but most popular. Mid drive connected conversion kit – less popular & tough to install. Brushed & Brush less DC motors. Crank Drive motors.

Kits 52
article thumbnail

Top 10 : Best Electric Bike Conversion Kit 2021 | Best ebike Conversion Kit | Best e Bike Conversion Kit | Electric Bike Conversion Kit With Battery

Electric Vehicless

Front wheel connected conversion kit- very easy to install but less popular. Rear wheel connected conversion kit – In comparison to front wheel little but tough but most popular. Mid drive connected conversion kit – less popular & tough to install. Brushed & Brush less DC motors. Crank Drive motors.

Kits 52
article thumbnail

Changes as I go

DIY Electric Car

50 inch aluminum plate as the first step of connecting the transmission to the electric motor. My plan was to connect the two Clark forklift motors together end wise. I found and bought a Caterpiller electric fork lift truck, the end result was that for $600 I got three 48 volt dc mortors, and a controller.

Volt 100
article thumbnail

Best speakers ever

Electric Auto Association

Founding EVA chapter connects with entrepreneurial stars. Much earlier in the chapter’s history, member Otmar Ebenhoech, who would go on to create the Villa DC Motor Controller, made a strong impression on the DIY community using DC motors. Otmar was one of our first speakers,” said Pohorsky. “He

EV1 52
article thumbnail

EV Solutions WarP-Drive Installation

DIY Electric Car

The WarP-Drive 160/1000 is a 160VDC, 1000 Amp continuous rated output DC controller. The WarP-Drive Interface Unit easily connects to the controller though the CAN bus using a common Cat5 network cable. WarP-Drive Interface Unit. WarP-Drive Interface Unit. WarP-Drive Standard Performance Cooling Kit.

article thumbnail

Arc 1 Conversion Journal 3/3/2012

DIY Electric Car

For tachometer, I will be using a sensor ring on the second shaft end of the motor connected to a new instrument. I bought an Advanced DC X91-4001. I will be using a GPS speedometer and odometer (The state of Utah does not care about ODO readings after the car is 10 years old). After much back and forth, I have picked one.