Remove Available Remove Installation Remove Netherlands Remove Re-Charge
article thumbnail

Tesla’s first V4 Superchargers in Europe are being spotted

Teslarati

Tesla’s first V4 Superchargers are being spotted in Europe just days after the company announced that initial installations have begun. Last Summer, rumors of the first-ever V4 Superchargers started to swirl as illustrations and specifications of what would appear to be the newest iteration of Tesla’s charging piles surfaced.

Europe 145
article thumbnail

Fraunhofer ISI/ICCT analysis of PHEV data finds real-world CO2 emissions 2-4x higher than official values

Green Car Congress

The lowest UFs were for China at 26% for private vehicles, Germany with 18% for company cars and 43% for private vehicles, and the Netherlands with 24% for company cars. Statistically, private users of vehicles in Germany re-charge their plug-in hybrid vehicle only on three out of four days.

PHEV 334
article thumbnail

IEA: Electric vehicles posted strong gains in 2016; 2M now in global parc

Green Car Congress

Six countries more than over 1% electric car market share in 2016: Norway, the Netherlands, Sweden, France, the United Kingdom and China. When available, stock numbers from official national statistics have been used, provided good consistency with sales evolutions. Electric car deployment in some markets is swift.

2016 186
article thumbnail

MAN eTGE battery-electric van to be mass-produced from July onwards

Green Car Congress

A 40 kW charging station fills a battery up to 80% in 45 minutes. Approximately nine hours are needed for a full charge with 220V AC. With the relevant battery maintenance, the 36 kWh rechargeable battery only loses around 15% of its ca-pacity after ten years and around 2,000 charging cycles.

Batteries 218
article thumbnail

The Scandalous History of the Last Rotor Cipher Machine

Cars That Think

A total of 12 different rotors are available for the HX-63, of which nine are used at any one time. To decrypt the message, those same rotors and settings, along with those of the modificator, must be re-created in the receiver's identical machine. A 12-volt DC linear power supply runs the motor and printer and charges the battery.