Remove Connected Remove DIY Remove Price Remove Volt
article thumbnail

A DIY E-bike Conversion on the Cheap

Cars That Think

Being an open-source design no doubt keeps the price of this hardware down: The controller I bought set me back a mere $85. Here I took advantage of already owning an electric lawnmower, figuring that the 40-volt, 4-ampere-hour battery I had for it would serve well. The third essential element of any e-bike is, of course, the battery.

DIY 145
article thumbnail

A DIY E-bike Conversion on the Cheap

Cars That Think

Being an open-source design no doubt keeps the price of this hardware down: The controller I bought set me back a mere $85. Here I took advantage of already owning an electric lawnmower, figuring that the 40-volt, 4-ampere-hour battery I had for it would serve well. The third essential element of any e-bike is, of course, the battery.

DIY 98
article thumbnail

Top 10 : Best Electric Bike Conversion Kit 2021 | Best ebike Conversion Kit | Best e Bike Conversion Kit | Electric Bike Conversion Kit With Battery

Electric Vehicless

Front wheel connected conversion kit- very easy to install but less popular. Rear wheel connected conversion kit – In comparison to front wheel little but tough but most popular. Mid drive connected conversion kit – less popular & tough to install. Battery capacity Watt-hours = Amp -hrs X Volts.

Kits 52
article thumbnail

Looking to get in a hybrid for cheap? Used Toyota Prius 1.5 HSD 2004-2009 Review

Green Car Congress

The drive went well, there were some minor things the car needed but it had a full service history and when I asked for a 500-dollar-lower asking price than list price, the seller accepted. You can use an independent hybrid shop to fix your pack for a much cheaper price. 11 volts, we can look for a new battery.

2004 409
article thumbnail

This Huge DIY Workbench Gives You a Hand

Cars That Think

Then I added an eyebolt for my air compressor—a fabulous tool for its roughly US $40 price—to keep it at the ready for blowing off excess material. I added a DIY solder squid—a block with four flexible arms that I use to hold components in place while soldering—with a concrete base and an automatic solder fume extractor. James Provost.

DIY 95
article thumbnail

Arc 1 Conversion Journal 3/3/2012

DIY Electric Car

For tachometer, I will be using a sensor ring on the second shaft end of the motor connected to a new instrument. Motor volts, amps, temperature will be showed on 2 inch round dials in the place of oil temp, 12V battery voltage, and fuel level. A new 'A' pillar instrument cluster will show battery pack volts, amps, and DOD.

article thumbnail

Automakers agree on common plug to recharge electric vehicles

Tony Karrer Delicious EVdriven

German energy firm RWE has stated that a cadre of respected automakers and energy firms have all come together in agreement on a three-point, 400-volt plug that will enable electric cars the world over to be recharged anywhere, regardless of which recharging station they stop at.