article thumbnail

US Tire Manufacturers Association to produce standardized tire tread particles for researchers

Green Car Congress

The US Tire Manufacturers Association (USTMA) will produce cryogenically milled tire tread (CMTT) and provide samples to researchers to advance scientific study on tire and road wear particles (TRWP). Earlier post.) Earlier post.)

Standards 418
article thumbnail

Eaton leverages cylinder deactivation and exhaust thermal management technologies to reduce commercial vehicle emissions

Green Car Congress

These agencies, in concert with other national and international regulators, seek to significantly reduce greenhouse gas (GHG) emissions and harmful air pollutants produced primarily by heavy-duty trucks, vans and buses. CDA technology can benefit vehicle manufacturers facing tightening emissions standards in Europe as well.

Eaton 221
article thumbnail

UK researchers report that alcohols in windshield washer fluid are major unreported source of VOCs emissions from cars, including EVs

Green Car Congress

A fleet average nonfuel nonexhaust VOC emission factor of 58 ± 39 mg veh –1 km –1 was calculated for the missing source, which is greater than the total of all VOCs emitted from vehicle exhausts and their associated evaporative fuel losses. While some VOCs are released in exhaust, others may arise from an unexpected source—e.g.,

Emissions 397
article thumbnail

Vitesco Technologies wins major order for electric heating elements for diesel catalytic converters in 48V MHEVs

Green Car Congress

Vitesco Technologies, formerly (until September 2019) the Continental Powertrain Division, has won a major contract from an European vehicle manufacturer for the supply of innovative electric heating elements for diesel catalytic converters. In the Super Clean Electrified Diesel, the efficiency of exhaust gas aftertreatment rises to 97%.

Convert 392
article thumbnail

Achates near-zero heavy-duty opposed-piston diesel enters fleet service; compliant with 2027 NOx levels

Green Car Congress

The cleaner engine is able to deliver ultra-low NO x by managing exhaust gas temperatures to ensure rapid catalyst light-off and by maintaining aftertreatment temperatures at optimum operating conditions in all driving conditions. It also uses existing components and supply chains.

Diesel 468
article thumbnail

UC Riverside team wins EPA design contest with lawnmower exhaust aftertreatment device

Green Car Congress

A team of University of California, Riverside Bourns College of Engineering students have won an EPA student design contest for developing an exhaust aftertreatment device that cuts CO, NO x and PM emissions from lawnmowers. A filter captures harmful pollutants. Also, the new device doesn’t stick out as far off the lawnmower.

Exhaust 261
article thumbnail

Mass spectrometer enhances SwRI’s USGR automotive catalyst testing

Green Car Congress

The combination of technologies provides simultaneous FTIR and mass spectrometry data, allowing accurate and rapid identification of exhaust stream components. The mass spectrometer can detect a broader range of exhaust components, allowing a more complete picture of aftertreatment system performance.

Pollution 305