Green Car Congress

JANUARY 6, 2011

The cathode material enables a 50—100% increase in gravimetric energy storage capacity over conventional cathode material, according to Argonne. Cathodes (ANL presentation by Dr. Michael Thackeray at 2010 Annual Merit Review DOE Vehicle Technologies Program). LG Chem Michigan, Inc.

Li-ion 210

Li-ion GM Ni-Li Lithium Ion 210

Green Car Congress

MARCH 12, 2010

Michigan-based electric powertrain company ALTe LLC ( earlier post ) revealed its demonstrator Ford F-150 range-extended electric vehicle conversion at the 2010 National Truck Equipment Association (NTEA) Work Truck Show and Green Truck Summit. Click to enlarge.

F-150 240

F-150 Convert Ford Electric Vehicles 240

Green Car Congress

MARCH 9, 2009

The prototype shown at Geneva is a forerunner of the vehicle which will go into production in Italy at Pininfarina starting from 2010 with the first units. The lithium-metal-polymer cell is a laminate of four ultra-thin materials: A cathode composed of vanadium oxide, carbon and polymer to form a plastic composite. The BLUECAR.

Pininfarina 186

Pininfarina Polymer Recharge Italy 186

Green Car Congress

DECEMBER 3, 2010

The electric truck and its battery system, which will be produced and assembled in France, were unveiled at Pollutec 2010 by PVI and its partner SITA, a subsidiary of Suez Environnement, alongside examples of Dow Kokam’s battery system technology. Dow Kokam and PVI are partnering on a small fleet of fully electric refuse trucks.

Fully Electric 199

Fully Electric France Lithium Ion Electric 199

Green Car Congress

AUGUST 7, 2009

With the initiation of the EFRCs in April 2008, the Department of Energy (DOE) budgeted approximately $100 million for multiple EFRC awards starting in FY 2009. awards are subject to FY 2010 to FY 2013 appropriations. Polymer-Based Materials for Harvesting Solar Energy. $16. Northwestern University. University of Arizona.

Energy 150

Energy Energy Storage Conversion Solar 150

Green Car Congress

AUGUST 20, 2023

This work aims to explore the effectiveness of using newly synthesized 2D graphyne-based membranes (namely graphyne, graphdiyne, and graphtriyne) for electrode protection in a solid polymer electrolyte battery through first-principle calculations, nudged elastic band method, and classical molecular dynamics simulation. Å, and 6.69

Li-ion 278

Li-ion Batteries Battery Polymer 278

Green Car Congress

JANUARY 18, 2014

The FOA will give equal consideration to all proposals submitted, including submissions that address the following Areas of Interest: Energy Storage R&D. cost titanium structures; polymer?metal The VTO FOA is open to any and all ideas which significantly advance the mission of the VTO. in electric vehicles (PEVs). and/or heavy?

Carbon Fiber 252

Carbon Fiber Engine Battery Powered Fuel 252

Green Car Congress

MAY 13, 2011

If there are strong sea winds, for instance, then surplus power supplies can be converted to e-gas and stored in the largest available energy-storage system: the public gas network. If necessary, this energy can flow from the gas network back to the power grid at any time. The electrolyzer runs on green electricity.

Audi 370

Audi Gas Hydrogen 2013 370

Green Car Congress

NOVEMBER 21, 2013

As Equus owners have enjoyed since its introduction in 2010, should a Tucson Fuel Cell require any service, a Hyundai dealer will pick up the vehicle and provide a loaner, then return their car after service to their home or business, at no charge. Two hydrogen storage tanks, with a total capacity of 5.64

Tucson 324

Tucson Honda Hyundai Concept 324

Green Car Congress

JANUARY 22, 2014

For the purposes of this AOI, a carbon fiber composite is defined as a composite that combines carbon fiber with polymer resin. The fibers can be continuous or discontinuous and the resin can be either a thermoplastic or thermoset polymer. 2010 Baselines. Peak engine efficiency point. 2020 Stretch Goals. Peak efficiency.

Emissions 252

Emissions Vehicles Fuel Economy Carbon Fiber 252