Green Car Congress

MARCH 31, 2014

Vehicle technologies span a range from new Si/graphene Li-ion anode materials and composites for motor windings to diesel aftertreatment and advanced lubricants. Hybrid Electric Turbocharger for Exhaust Energy Recovery and Transient Lag Reduction. Low-Cost, High-Energy Si/Graphene Anodes for Li-Ion Batteries.

Exhaust 261

Exhaust Wind 2014 Motor 261

Green Car Congress

AUGUST 10, 2011

This project will develop a new process that enables low-cost, domestic manufacturing of magnesium. This project will develop a novel low cost route to carbon fiber using a lignin/PAN hybrid precursor and carbon fiber conversion technologies leading to high performance, low-cost carbon fiber.

Carbon Fiber 268

Carbon Fiber Lithium Ion Li-ion Vehicles 268

Green Car Congress

JANUARY 18, 2014

Specifically: the current cost of high?energy ion batteries is approximately four times too high on a kWh basis; current batteries are two to three times too heavy and large, and high? ion batteries are not intrinsically tolerant to abusive conditions. burn and exhaust gas recirculation (EGR)?diluted energy batteries.

Carbon Fiber 252

Carbon Fiber Engine Battery Powered Fuel 252

Green Car Congress

OCTOBER 30, 2022

This is a low-volume, high-value market where aircraft will rely on high-cost and cutting-edge technologies to reach new heights with regard to performance and safety. For example, IDTechEx expects that lithium-metal and solid-state batteries, axial flux motors, and carbon fiber materials will play an important role in eVTOL markets.

Market 150

Market Electric Vehicles Vehicles Cars 150

Green Car Congress

DECEMBER 16, 2010

The objective of this AOI is to accelerate the realization of lighter weight vehicle materials made from magnesium and carbon fiber capable of attaining 50% weight reduction of passenger vehicles. Subtopics include: Low-Cost Development of Magnesium. Development of Low-Cost Carbon Fiber.

Li-ion 231

Li-ion Carbon Fiber Vehicles Low Cost 231

Green Car Congress

AUGUST 16, 2016

Accelerated Development and Deployment of Low‐Cost Automotive Mg Sheet Components (Area of Interest 3). Demonstrate the joining of steel to aluminum and aluminum to carbon fiber reinforced thermoplastic composites using the existing spot welding infrastructure. Description. Federal funding. Federal funding. Description.

Vehicles 150

Vehicles Plug-in Lithium Ion Universal 150

Green Car Congress

DECEMBER 20, 2013

Possible areas of interest for the EV Everywhere Grand Challenge include, but are not limited to: Development of low-cost, high-strength automotive aluminum sheet. Integrated computational materials engineering (ICME) development of carbon fiber composites for lightweight vehicles. Beyond Li-on.

Vehicles 246

Vehicles Fuel Economy Carbon Fiber Plug-in 246