The EU plans to extend its climate goal of reducing CO₂ emission of new vehicles by 37.5% until 2030 to heavy-duty vehicles. In 2019, 409,801 commercial vehicles were registered in Germany, of these, 38,620 semitrailer trucks. So far, they have not been subject to any CO₂ reduction requirements.

Within the KliMEA project, researchers at Karlsruhe Institute of Technology (KIT) will study drive systems of heavy duty vehicles and fuel cell technology to find ways how future production of fuel cell components can be adapted to these expected new emissions requirements.

Fuel cell technology appears promising to reduce CO₂ emissions of heavy-duty vehicles by 15% until 2025 and 30% until 2030.

Apart from the use of synthetic fuels, we consider hydrogen to have a great potential for energy supply of commercial vehicles. First vehicles are already available. However, fuel cell development must be accelerated considerably for a planned introduction by 2025. The pace of fuel cell development will be set by production technology.

—Dr. Nicole Hoffmeister-Kraut, Baden-Württemberg Minister of Economic Affairs, Labor, and Housing

A crucial step of fuel cell production is manufacture of the membrane electrode assembly (MEA). The MEA is a composite component. Its core piece is the polymer electrolyte membrane (PEM). The PEM is just a few micrometers thin and changes considerably when moisture changes.

This may cause damage, cracks or detachments, as a result of which the entire composite component can no longer be used. To prevent this, temperature of the production area must be controlled.

Installation of such a system requires a long planning horizon and is associated with high costs for both procurement and operation. Within our research project “KliMEA” we study ways to locally control the temperature of the MEA component by a so-called microenvironment. The PEM is placed under a type of bell jar to maintain the right climate and is then subjected to further processing.

This process could make MEA production flexible as far as the numbers of pieces produced are concerned, it may accelerate production and, hence, reduce the consumption of resources and costs.

—Professor Jürgen Fleischer, Head of KIT’s Institute of Production Science (wbk)

Schematic representation of roll-to-roll MEA manufacture. (Figure: wbk, KIT)

“KliMEA” is the German acronym of “climate-adaptive and model-based membrane electrode assembly manufacture.” Two wbk groups are involved in the project. As a project partner, the Thin Film Technologies (TFT) group of KIT studies moisture absorption by the PEM. This component considerably influences the behavior of the MEA. It becomes longer or shorter when air moisture changes. On this basis, a wbk team simulates the impacts of PEM changes on the MEA to obtain the required process knowledge.

Using a digital twin, the second team of wbk studies connection to the real system and derives suitable measurement strategies. The data collected are needed for quality assurance and traceability. On this basis, it can be decided whether use of a certain assembly is associated with a risk and countermeasures have to be taken.

The associated project partner Daimler Truck Fuel Cell GmbH is contributing its knowledge in the area of industrial MEA manufacture. e-mobil BW GmbH supports the project by making available its experience gained in the management of the Fuel Cell Cluster of Baden-Württemberg. Within the Strategy Dialog for the Automotive Sector in Baden-Württemberg, the State Ministry of Economic Affairs, Labor, and Housing funds the research project with about €1 million until late 2021.